The raw material should be dried by the dryer (The moisture content is about 15%) → Feed into briquette machine → High temperature and high pressure, curing, stamping forming → Cooling → Package → Leave the factory.
The main motor is driven by the eccentric wheel to move 280 times per minute. The screw feeding machine starts to feeding the raw material, then the raw material will feed into the briquette machine of the feeding box by the dealer, and then will into the press room by the screw delivery from the left and right sides. The raw material will be pressed by the punch and mold, then heating-up and soften, and the volume is smaller.
It introduces novel and unique sealing device, and is matched with thermal insulation system of excellent effect, thus decreasing the coal consumption of the whole drying system.
Dryer internal structure using a variety of high-lift board combination mode, effectively regulate the drying process and heat distribution, high heat utilization, exhaust gas discharge temperature is low.
Rapid drying moisture reducing from 65-75% to 14-18% in one-time. Pasture temperature is always lower than 50 ℃, dried grass completely retained the nutrients of fresh pasture, bright color, smell fragrance.
Supporting a variety of new energy-saving clean hot air blast stove, fuel can be diesel, gas, coal, wood, wood chips, straw etc. And efficient energy, heating controllable, simple operation, energy consumption decreased by as much as 30%, power consumption reduced by 20%, the operating cost is lower.
|Diameter of Pellet (mm)||8、10、20、30、40、50、55、60、65、70、85|
|Product Density (g/cm3)||1.0-1.3|
|Main Motor Power (Kw)||45||75|
|Auxiliary Motor Power (Kw)||15||21|
|Overall Dimensions (mm)||L3400*W2000*H1800||L4500*W2000*H2000|
Stamping Type Biomass Briquette Main Technical Parameter List